Thanks Geoff.
I have another project I have high hopes for as well.
I'm having a gas tank built by Franco and Alex Castagno.
They have a company that builds metal boxes and are geared up for it.
I was going to go with making a composite tank but I've never run Ethanol and don't want to take a chance for obvious reasons.
Castagno are going to put a 80mm radius on all the bends instead of a sharp 90*.
I'll have to baffle it, mount the fittings and fit the lid.
I went with steel because I don't have the experience or a welder for Aluminum.
This is a fuel injected application of which I also have no experience and I need to know how many lines to fit and what filler is best for the safety aspect.
I know most of you will have good advice and I'm looking forward to reading the replies.
I have one of these fillers here but just need to find it.