Don't laugh, OK???
I'm nothing like these guys but I do have my work cut out.
The place is rudimentary at best.
I don't think we'll run on the same stretch of track either.
http://www.youtube.com/watch?v=Uli51c35oY4The tub sits on a steel frame and is fastened at 12 locations.
The frame is bolted to the chassis with five fixtures on each side and two each out front and rear.
The tub also attaches directly to the chassis at four points.
Safety harness attaches to the chassis low down on the bulkhead below the roll cage and then other mountings go through the Carbon to the steel lower frame on the sides.
Believe me, if there was an easier way to fit the tub I would have used it.
A rough estimate is that it all goes together with 34 fasteners but the cool thing is that once it's all together there won't be a reason to take it apart.
Thanks for the advice on the chute system Sum.
Pete, my orthopedic surgeon said I have so much steel in my leg that if I break it again he'll have to weld it together.