I was just reading what Sparky said about having a "honey do" that put the Widl Weasel on hold.
I've been mentally preparing myself for a week to start cutting the Carbon/honeycomb panels I'll be using fror making up the driver's cell.
Useless information probably but if you ever have to cut or route cured Carbon fiber use air tools. Carbon fragments and dust destroy electric power tools. If you have to use electric cover all vent holes with tape and make sure the duty cycle is short.
If you thought Fiberglass could make you itch Carbon will kill ya!. No bull. You'll beg for a bullet.
I have a "suit" I use. A towel over my head then a hoodie. 3M mask, motocross goggles and gloves that are duct taped over the sleeves. Denims also taped over the boots. I'm in this for the long haul. I'm just about ready to start routing and then MICKEY!!!!! the washing machine....... water all over....... I think it's the pump?.
After the rant, rave and repair everything I touched turned to junk. Back to the washing machine. I turned the thing on it's side and took the back panel off looking for the pump. It's attached to the front panel and you can't get it off from the inside. I somehow missed the cover on the bottom front of the machine that has two quarter turn fasteners that allow for pump servicing and filter removal. 2 hours of foul language and trying to impress on the woman that I don't know Jack about washing machines, toasters, dish washers or boilers. They give you that look. They glance towards the shop indicating that you're building a car but YOU can't solve a small problem on a washing machine. Honey I don't even think I know what I'm doing in the shop either!.