Some pics.
Rich mounted the oil pump but the lower fitting was hitting the pan rail
So off it came to mill a new set of slots that would raise the pump slightly and allow the fitting to clear the rail. These are just a series of pics. For the most part I just tried to stay out of Rich's way.
Rich made some screws with points on them, we marked the plate on the car but then Rich wanted to make sure we had the right marks and them make them nice a deep
Center drill
Milling the slots
The first new slot milled, the pencil marks are where the others will be
Pump remounted
We looked at the fuel pump for a while. I think Rich decided where he wanted it but it was like a presidential election, what is the least bad choice. He wanted to think about it during the week and probably work without me looking over his shoulder. I imagine that if he gets it mounted he will post a pic.