Some pictures from today
We machined the areas around five of the head bolt holes to make sure they were flat. Some of the holes had to have a drill run through again to make certain they were clear of weld. Then we tried it on the block.
Once we knew the head fit again, we started on the spacer for the intake side. It is going to adapt the the fuel injection intake and cover up the part of the block the head doesn't cover.
First we made a pattern off the head
Rich blued the aluminum selected for the job at hand.
Then to the mill
We drilled some 7/8" holes and that was it for the day. Rich gets tired watching me fumble around at his mill so he needed me to stop.
I suspect if he will post some pics later this week.