Mike, I've done several boat repairs with epoxy and it's the sharp corners that give me fits. I'm going the wimpy route with poly and mat. I noticed there's a mat out now that can be used with epoxy but I can't get it locally and I need to get this done while I've got the week off.
Made good progress today but won't be ready for glass tomorrow. Too many final prep things to do. Masking, release wax, etc. Most of all I need to clean the shop!!
Top & center pics; Finished the "turtle shell" over my legs and the tail cone. I've started the bump for rear tire clearance. That bump will end in a horizontal fence at the rear of the tail cone. I figure it will add a little stability (except in crosswinds) and look kinda' coolish.
Bottom pic; The full side profile is visible now. I'll cut the tail cone off at 10" after the body and wheel is mounted. Add an inch for the front fender and it's going to come in right on the money at 107" overall (Yayyy! Something actually came out like I planned it !!)