Author Topic: And another new streamliner  (Read 2595 times)

0 Members and 1 Guest are viewing this topic.

Offline Tom Slick

  • Full Member
  • ***
  • Posts: 179
    • http://www.ccrsport.com
And another new streamliner
« on: December 25, 2008, 02:25:38 PM »
I'm not sure if this has been posted before and I apologize if it has, but I just found this on You Tube and thought I'd share it here: http://www.youtube.com/watch?v=E6UTXMfxXlU

Offline Rex Schimmer

  • Hero Member
  • *****
  • Posts: 2633
  • Only time and money prevent completion!
Re: And another new streamliner
« Reply #1 on: December 25, 2008, 04:43:58 PM »
I think that is the old "Roy Fjasta/Junior Kurtz" car. Last ran in 2006 and has gone as fast as 311 with a 499 inch big block on alky. Held the AUB/FS record for a year before the Nish's put in a small motor and raised it to aroung 344. I understand they are doing alot of body mods.The car was a real "bluff body" before.

Looking forward to seeing them run, Fjasta built the car so it is very nice and has a well engineered chassis. Always heard that it handled well, of course it wasn't going 400 either!

Rex
Rex

Not much matters and the rest doesn't matter at all.

Offline maguromic

  • Hero Member
  • *****
  • Posts: 1736
    • http://www.barringtontea.com
Re: And another new streamliner
« Reply #2 on: December 25, 2008, 04:54:44 PM »
I was over at their shop on Friday to pick up some tubing and looked over the liner.  Rex I think  you are right its the old "Roy Fjasta/Junior Kurtz" car.  These guys have put together some fast cars over the years in all forms of racing, so this endeavorer should be no different.  I cant wait to see it run.

Tony
“If you haven’t seen the future, you are not going fast enough”

Offline Roadsters.com

  • Full Member
  • ***
  • Posts: 199
    • Roadsters.com
Re: And another new streamliner
« Reply #3 on: December 25, 2008, 04:56:08 PM »

Offline t russell

  • Sr. Member
  • ****
  • Posts: 579
Re: And another new streamliner
« Reply #4 on: December 28, 2008, 10:16:21 AM »
Thanks for the vid.
terry