Thanks Pete, Neil and Ed.
I finished welding the tank so I filled it with water
to check for leaks. I found one and will close it
in the AM.
Even though I sealed the tank and back purged
I don't like the look of the weld inside.
I have special fan grinders for Stainless and I was thinking
I should clean up the inside and run a bead over the joint
to make sure. It won't be possible to back purge though.
I want to weld in the bungs for the fuel lines. This is for EFI
and I was told to run 2 fuel pumps for the 2200cc injectors.
I checked on Aeromotive's site and it looks like -10 should be
the right size for the application.
My thinking is 2 bungs for the injectors but heard I need a return
mounted in the same area and not at the top of the tank.
Seeing as I have 2 pumps do I need 2 returns?
?.
I'll wait to hear from the experts. Thanks guys.