« previous next »
Pages: [1]   Go Down

Author Topic: Flowbench  (Read 1457 times)

0 Members and 1 Guest are viewing this topic.

Offline 38flattie

  • Hero Member
  • *****
  • Posts: 2169
    • http://www.flatcadracing.org/
Flowbench
« on: November 06, 2012, 09:42:45 AM »
I'm looking to buy or trade for a flow bench. It doesn't have to be anything fancy, just usable.

Thank you in advance!
Logged
With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin

http://www.flatcadracing.org/
http://youtu.be/89rVb497_4c

Offline hotrod

  • Hero Member
  • *****
  • Posts: 1231
    • Black Horse photo
Re: Flowbench
« Reply #1 on: November 06, 2012, 03:53:37 PM »
There are plans on line to build your own flow bench using commodity vacuum motors.

Have you looked into that option?

Such as this:

http://performancetrends.com/ez_flow_system.htm

Larry
Logged
Pages: [1]   Go Up
« previous next »