Landracing Forum
East Coast Timing Association => ECTA Rules Questions => Topic started by: oldkamikaze on February 02, 2011, 10:01:25 AM
-
Hi Bill Here. Metal valve stems on motorcycles, do the have to be straight or 90 degree. If they are 90s should I run them with the wheel or come out the side. Thanks in advance Bill
-
straights are the best.
pretty sure some org. won't allow 90's.
at one time (still?), 90's had to be safety wired.
a rule book for where one plans to run is needed.
franey
-
I am pretty sure that the flexible 90's were only legal up to a certain speed and had to be safety wired. The steel 90's are ok for ECTA as is.