Landracing Forum
Fundraising, For sale, and Wanted => For Sale by Private Parties => Topic started by: Rick Byrnes on August 28, 2012, 11:57:02 AM
-
Used only 6 passes & decided I wanted suspension.
MW 32 spline 1.375" shaft
MW 40603A for 10spline rear. V8 or midget center
MW 40640A female coupler
MW 40780 male coupler
2 stainelss lock rings and 2 4130 lock rings
All parts except the lock rings are Non-Electrolitic Nickle plated
(no hydrogen embridlement)
Want $300
Rick@RBMotorsports.com
-
Rick what is the length?
-
HI Glen
only 8 inch length.
-
Rick,
What material is the shaft?
What is the trans coupler?
Where are you measuring the 8"?
Sid.
-
Sid
8 inch is overall length.
I'm guessing the shaft is 4130 which is their base alloy, but I didn't originally purchase the parts.
Trans is Jerico 4 spd clutchless and I think is 32 spline. I will go out to the shop and count. First I need to cut the grass which will keep the little red haired girl happy. Later today.
-
My front one is 13" but it might fit the rear. I'll be putting the B&J back in to check length while you're on the grass.
Sid.
-
Sid
The trans coupler is 32 spline, but about .010" smaller diameter than the shaft and other parts which of course makes the splines a little finer. When I replaced the coupler, I ended up with a real bastard flange for u joint and 2 piece shaft. Kinda like a 4WD front shaft.
Hope this helps
-
Sent you a pm.
Sid.
-
bump
-
Rick, thanks for shooting me a note. I will look at my stuff and see if this will work tonight.