Landracing Forum

Tech Information => EFI Questions => Topic started by: oz on June 02, 2010, 04:04:42 PM

Title: To swirl or not to swirl
Post by: oz on June 02, 2010, 04:04:42 PM

I have been looking at the head and a question springs to mind.
The Throttle bodies are of a zx10r and they come in two banks of two and the pitch is 84mm
The pitch of the Cylinders is around 90mm which dosent give alot of offset for swirl would it be beneficial to?

A.put the two halves of the bodies at a slight angle to each other as viewed from above maybe 4or 5 degrees just to get a bit more of a swirl effect.

B.Not worry about it as it aint gona make a huge difference as the small 6mm offset will do the job ok.

Cheers fellas Oz

Title: Re: To swirl or not to swirl
Post by: BVCBR on June 02, 2010, 07:20:27 PM

Do you have a picture of the throttle Bodies you could post?

JW

Title: Re: To swirl or not to swirl
Post by: oz on June 03, 2010, 02:08:08 PM

Yup this is the little blighters.

(http://i215.photobucket.com/albums/cc215/ozcoatswith/P1000968.jpg)

(http://i215.photobucket.com/albums/cc215/ozcoatswith/P1000967.jpg)

(http://i215.photobucket.com/albums/cc215/ozcoatswith/P1000966.jpg)

(http://i215.photobucket.com/albums/cc215/ozcoatswith/P1000965.jpg)