Landracing Forum
Bonneville Salt Flats Discussion => SCTA Rule Questions => Topic started by: floydjer on March 24, 2008, 07:59:42 AM
-
In sec. 3.L and 3.T the rule book says ..(solid type Heim joints are required) Does this mean non-drilled solid shank, or all metal non-insulated bearing surface? Jerry
-
the heim has to have a ball to swivel otherwise it wouldnt work--im a bike guy but we have the same solid heim rule i take it to mean no hollow shaft heims --i have also seen heims with zerk fittings these are hollow then the rule says washers are required that are bigger than the heim so it will be retained if seperation (of the ball) occurs willie buchta
-
the heim has to have a ball to swivel otherwise it wouldnt work--im a bike guy but we have the same solid heim rule i take it to mean no hollow shaft heims --i have also seen heims with zerk fittings these are hollow then the rule says washers are required that are bigger than the heim so it will be retained if seperation (of the ball) occurs willie buchta
"sheri"
Better put the key board down and go weld... :mrgreen:
J
-
hey john good to hear from you hope you and yours are all in good health willie buchta