midget,
Just a thought. Prior to totally dismembering the 'K', we will need a couple of measurements:
1) Crank hub to rear of block face dimension. Needed to engineer new billet crank to use existing BMC 'A' flywheel, starter, gearbox, input shaft, etc.
2) It would be useful to measure the existing valve to piston dimensions @ various points BTDC & ATDC, for both valves. This would establish a starting point for piston
design.
3) Anything else you can think of.
No rush on any of this, just want to put in the request before you start rippin' into it.
Wantin'tothinkaboutitfirstboy
yeah I know, there I go thinkin' again . . . . . . . .