Of course, one of the neat things about race bikes is the simplicity of wiring them, right? No annoying lights, turn signals etc.
Yeah, right! 2 weeks in, I'm about done
My own fault for getting all fancy with fuel-injection.
I've had it cranking over so far but couldn't get oil pressure until I overfilled the tank. Dry old pump wouldn't suck enough! I dont have a gauge, but the way the starter slowed when the oil light went out indicates theres plenty pressure.
Heres the completed loom: After reading of Oz's VR signal woes, I went overboard screening not only the VR sensor wires, but also the coil & injector circuits. Shredded a couple of old printer & antenna leads to get the braided stuff.
Here it is installed: The 3 relays are: main system, fuel pump & starter.The loose coiled wire is the ECU bootlogger connection. Grounding this clears the ECU code. I wont be doing that!
Heres the wideband oxygen sensor module with MAP sensor & main circuit breaker.
VR sensors:
Injectors: