Gairdner was good--and bad---Greg was having issues sorting his Busa and trying to get he H-2 back together and dynoed. I arrived thursday and we started wrenching hard friday morn. Chasing a miss on the Busa we replaced plugs, ignition module, coils, and ecu with no luck so ended up replacing entire wiring harness and back to the Gen 2 ecu from the past and finally got good runs on the dyno. I worked on getting rearsets made and bars back on the H-2 readying it for the dyno. It was just coming in with maybe 2 runs to go--(sounding wicked ) when the tuning system tanked. This set-up required a internet connection to tune and we think THEIR server went down, so no ignition etc. Left it on the dyno, dang it!! (Geg has since got it back running, thinking of bringing here this year!)
We arrived two days late and a bike short at the Salt. I went out first on the Busa running naked and was going well coming into the timing when there was a soft "pop" and it started loosing speed, ran back to pits on a 3 cylinder. Log showed no problems with air/fuel so not sure what happened, but it was done.
Kim had a couple runs on the 750 and had some rust to knock off so she ran 200+ in fifth and the next run had a miss up top. We changed plugs and found a loose ground wires so I took the bike out the next morning( the last day) and it was good through fourth but would not pull fifth. Seems the boost controller was playing up. There was not time to do anymore so we packed it up and headed for home.
It was a great time and saw lots of friends. ----AND--- got a 2 club hat from Down Under to add to the collection!!! :banana: