Landracing Forum

Bonneville Salt Flats Discussion => Bonneville General Chat => Topic started by: Dynoroom on November 30, 2006, 03:04:25 PM

Title: Picture attachments
Post by: Dynoroom on November 30, 2006, 03:04:25 PM

Just trying to see if I can do it

Title: Re: Picture attachments
Post by: PorkPie on November 30, 2006, 03:06:42 PM

If you make now a klick on the picture it open in second window with the big size, only this size is limit to 128 KB - but earlier test shows that this is more than enough.

Title: Re: Picture attachments
Post by: Sumner on November 30, 2006, 07:46:29 PM

Quote from: Dynoroom on November 30, 2006, 03:04:25 PM

Just trying to see if I can do it

Mike couldn't you at least used a picture of a decent looking motor :wink:.

Wow that is a beauty.  Is the compressor gear driven off of the crank snout?  From Phoenix?

c ya,

Sum

Title: Re: Picture attachments
Post by: Bow on November 30, 2006, 08:12:21 PM

That is a bad looking engine...  :evil:

Title: Re: Picture attachments
Post by: Tom Bryant on December 01, 2006, 06:46:39 PM

What a beautiful powerplant. What will it fit in...not my car for sure!

Title: Re: Picture attachments
Post by: Harold Bettes on December 01, 2006, 11:33:17 PM

Dynoroom,

What a pretty engine pic!

What is the drive ratio on that hulamongo blower?

BTW - Check your messages.

Regards,
HB2

Title: Re: Picture attachments
Post by: Dynoroom on December 02, 2006, 12:53:48 AM

Thanks to everyone for the kind replies. Here's a picture of the drive, I hope...

Title: Re: Picture attachments
Post by: Dynoroom on December 02, 2006, 01:05:58 AM

A couple more  :-o

Title: Re: Picture attachments
Post by: dwarner on December 02, 2006, 12:18:20 PM

Mike,

You are going to have to run a clear hood on the car so that the engine is always available to view.

DW

Title: Re: Picture attachments
Post by: 1212FBGS on December 06, 2006, 12:26:13 AM

the exhaust looks pretty wild.... musta took quite a while ta make it.
kr

Title: Re: Picture attachments
Post by: jimmy six on December 06, 2006, 12:40:31 AM

Mike. Do you have any problems spinning the alternators as fast as it appears you do with the pullys in the pics...Thanks