« previous next »
Pages: [1]   Go Down

Author Topic: Aftermarket Early Ford Hubs Needed...  (Read 1925 times)

0 Members and 1 Guest are viewing this topic.

Offline Kiwi Paul

  • Sr. Member
  • ****
  • Posts: 494
Aftermarket Early Ford Hubs Needed...
« on: December 17, 2010, 12:05:02 AM »
I need a pair of Wilwood or similar Aluminum hubs with a 5 on 4.5 bolt pattern. These must fit Early Ford Spindles, 39-48. Don`t need calipers,rotors etc, just Hubs, good if they had new bearings too....These are for my almost stillborn Comp Coupe project...need to make it a roller. Could also use a pair of Chassis Engineering Bolt on Forged Steering arms to fit early Ford Spindles as well.......Can Anyone Help? :?
Logged

Offline johnneilson

  • Sr. Member
  • ****
  • Posts: 502
Re: Aftermarket Early Ford Hubs Needed...
« Reply #1 on: December 17, 2010, 10:19:47 AM »
Paul,

I just a couple months ago went through this.
I found that Summit racing had them available for about 125 ea.

John
Logged
As Carroll Smith wrote; All Failures are Human in Origin.

Offline 4-barrel Mike

  • Hero Member
  • *****
  • Posts: 3173
  • Any fool can drive a V8
Re: Aftermarket Early Ford Hubs Needed...
« Reply #2 on: December 17, 2010, 12:38:39 PM »
K.P.:

   I have a new set of C.E. AR-2119M (short drop, milled) steering arms that I won't be using.  Do you have my number?

Mike

edit (fixed typo and...) if you NEED to make it a roller, I've got enough stock stuff here that you could borrow.
« Last Edit: December 17, 2010, 01:40:09 PM by 4-barrel Mike »
Logged
Mike Kelly - PROUD owner of the V4F that powered the #1931 VGC to a 82.803 mph record in 2008!

Offline Kiwi Paul

  • Sr. Member
  • ****
  • Posts: 494
Re: Aftermarket Early Ford Hubs Needed...
« Reply #3 on: December 22, 2010, 12:43:03 AM »
Between Kiwi Sid and 4BBL Mike, I have both Parts and ideas, and now for the Rear End Mods.......Thanx Fellas... :cheers: :cheers:
Logged
Pages: [1]   Go Up
« previous next »