With just these simple tools I will now demonstrate how to make a Fuel Pump mounting boss
Wizz the trepanning tool around at the slowest speed possible and remember to hold on two the pedastle drill in cas it wobbles itself out the door of the shed.
Make a groove about 1.5mm deep in a kinda circle and then decide that the tool you are using is never ever going to go through 5mm steel plate,oh and remember ear plugs unless you love screaching squealing high frequency noise!!
Chain drill another bit of steel and knock the centre out with a big hammer,Then repeat the operation for the outside circle.
Pop a few holes through it in the appropriate places tap and counter bore to accept the heads of the bolts for plug welding and voila!
Then its time for some really technical stuff I laugh in the face of CAD designers,,, well not really just a few dimensions for the new intake spigots
CAD drawings done just need to source the ali
Redundancy looms yet again so progress may have to slow down somewhat.
TTFN Oz