(Note: LANDRACING.COM donations are not tax deductible)


This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Author Topic: Cb160 Turbo Project Pictures  (Read 8741 times)

0 Members and 1 Guest are viewing this topic.

Offline Chaulkdust

  • Full Member
  • ***
  • Posts: 60
  • Age: 74
  • Location: Homossas FL
Re: Cb160 Turbo Project Pictures
« Reply #15 on: July 15, 2010, 07:35:27 PM »
I am running a small FACET fuel pump good for 10-11psi. I needed the fuel pump since the boost pressure actually slows/stops the flow of gas to the carbs. So I have a boost adjusted 1:1 Mallory regulator that increases the fuel pressure as the boost rises. I set the initial fuel pressure at 2 psi or so and the regulator does the rest.

Right now I'm running the stock point setup, but I plan on putting in a pertronix electronic ignition setup before I go to BUB.

I'm using a RHB31 Turbo (the smallest I could find).
Ron Pavlak
Florida

Offline racer x

  • Sr. Member
  • ****
  • Posts: 578
  • Age: 56
  • Location: East Coast
  • Dark Horse Racing 10-B
Re: Cb160 Turbo Project Pictures
« Reply #16 on: July 15, 2010, 08:50:28 PM »
It was great to see you and you bike at Maxton . I hope Bonneville will be cooler.Best of luck at BUB .I hope you will be back at Maxton in September.
Thank you to all the volunteers

Offline Chaulkdust

  • Full Member
  • ***
  • Posts: 60
  • Age: 74
  • Location: Homossas FL
Re: Cb160 Turbo Project Pictures
« Reply #17 on: July 15, 2010, 09:56:51 PM »
Thanks Eric, yep I'll be back in Sept & Oct for more attempts (assuming the bike still running after BUB :roll:). Great meeting you and all the other folks, seems like we were in line together a lot at the starting line in the 96 degree heat!
Ron Pavlak
Florida