Author Topic: Motorcycle Sprocket.......learning Mastercam X4  (Read 1549 times)

0 Members and 1 Guest are viewing this topic.

Offline isiahstites

  • Hero Member
  • *****
  • Posts: 1152
Motorcycle Sprocket.......learning Mastercam X4
« on: January 18, 2010, 12:00:30 AM »
I am taking classes to learn the mastercam software and thought I would share the process..........very challenging but I really enjoy the process.

Here is what I have so far........basically I am reverse engineering. This is an HD/Buell sprocket 46 tooth.




Using the very top circle on the Y axis I created two points and drew a tangent line to each point, I then copied this to all 46 teeth, after that I add the top portion of the sprocket to 1 tooth and copied it the remaining 45 teeth.




Almost finished





Blown up for the detail


.250 thick


Here is what I modeled my drawing off of



Offline isiahstites

  • Hero Member
  • *****
  • Posts: 1152
Re: Motorcycle Sprocket.......learning Mastercam X4
« Reply #1 on: January 18, 2010, 11:50:19 AM »
Is anyone on here using Mastercam?