Author Topic: Roll Bar Question  (Read 3158 times)

0 Members and 1 Guest are viewing this topic.

Offline EastKY

  • New folks
  • Posts: 3
Roll Bar Question
« on: December 17, 2008, 04:32:49 PM »
Is a removable harness bar ok to use on the required 4 point bar for the Super Street class?  135 -149 mph

Offline MIKE MATY

  • Full Member
  • ***
  • Posts: 180
Re: Roll Bar Question
« Reply #1 on: December 18, 2008, 04:48:56 PM »
A harness bar will not get you a 150mph tech speed. You will only get 135mph tech speed. Unless you have a vehicle with an integrated roll stucture (ie vette/viper) Then you can get a 150tech with harnesses.
ECTA 200MPH CLUB Maxton
A/FRS      205.531
D/FSS      159.427
ECTA 200MPH CLUB Ohio
A/FRS       208.530
2013 Hot Rod Top Speed Challenge Winner

Offline EastKY

  • New folks
  • Posts: 3
Re: Roll Bar Question
« Reply #2 on: December 20, 2008, 12:11:16 PM »
I think there is some confusion...what I am talking about is a 4 point bar being installed with the cross brace behind the drivers head being removeable, bolts in and out to keep the back seat functional.

Offline t russell

  • Sr. Member
  • ****
  • Posts: 579
Re: Roll Bar Question
« Reply #3 on: December 20, 2008, 08:26:07 PM »
Is a removable harness bar ok to use on the required 4 point bar for the Super Street class?  135 -149 mph
Yes it can be done.I would go for the 6 poiint.
Contact Joe Timney/Keith Turk. On the best way to do it.
terry

Offline EastKY

  • New folks
  • Posts: 3
Re: Roll Bar Question
« Reply #4 on: December 20, 2008, 10:07:05 PM »
Do you have any contact information?  I have tryed to email Joe Timney a few times and I don't think the email get's there.

Offline t russell

  • Sr. Member
  • ****
  • Posts: 579
Re: Roll Bar Question
« Reply #5 on: December 21, 2008, 09:45:03 AM »
Joe can be reached @ 302-378-3013. M-F 9-5
terry