« previous next »
Pages: [1]   Go Down

Author Topic: 90 mm tbi  (Read 3565 times)

0 Members and 1 Guest are viewing this topic.

Offline KEVIN

  • New folks
  • Posts: 14
90 mm tbi
« on: October 11, 2007, 08:49:04 PM »
Can anyone  tell me what a 90 mm throttle body will flow in CFM?
Logged

Offline Peter Jack

  • Hero Member
  • *****
  • Posts: 3776
Re: 90 mm tbi
« Reply #1 on: October 11, 2007, 10:37:36 PM »
Depends on how much displacement is trying to pull the air through.

Pete
Logged

Offline fwillyj

  • Full Member
  • ***
  • Posts: 62
Re: 90 mm tbi
« Reply #2 on: October 11, 2007, 11:39:43 PM »
-the effective square inch area of a 90mm throttle body would be about 8.5 square inches.

-from testing I have done at 25" of water test pressure----I'd suspect about it would flow about the same as typical race prepared ports that I have measure to flow between 96 and 126 CFM per square inch.

-so this would 816 to 1071 cfm.

-in comparison I have found a variety of sharp edge orifices to all flow flow 84.4 CFM per square inch----and a variety of simple venturi shapes about 3.5" long that all flow within 200 to 209 CFM per square inch.
Logged
Pages: [1]   Go Up
« previous next »