Author Topic: Getting ready for Bonneville(rebuild)  (Read 1907630 times)

0 Members and 3 Guests are viewing this topic.

Offline rightytighty

  • New folks
  • Posts: 3
Re: Getting ready for Bonneville(rebuild)
« Reply #915 on: February 07, 2010, 04:40:06 PM »
Hey Troy,

Enjoy your thread but your videos could use some help.. Not trying to be a jerk, but this product is cheap and works great.

http://www.goprocamera.com/products

I mentioned this to you, last time we chatted at the pizza joint..

We use it on drag boats.  The wind noise is muted and you still get to enjoy the engine sounds.  The wide angle  view is killer..  We mount one forward and one back ward.. Bad ass..

Here's a sample from a K boat.. (it's a blown alcohol roundy-round boat).  Takes about a minute to get it warmed up, but it's a real good example of the quality.. You'll see one of the cameras suctioned to the nose of the boat in one of the angles..

http://www.youtube.com/watch?v=jb69AWD8geE&feature=player_embedded

Best $300 you'll spend this year IMO...   Mostly because, I'll be able to see your car run a little more clearly.....

Selfish interest!  :-D


Neil

Offline jl222

  • Hero Member
  • *****
  • Posts: 2957
Re: Getting ready for Bonneville(rebuild)
« Reply #916 on: February 08, 2010, 12:48:49 AM »

  Looks like a great little video camera Niel. Dang I just bought another brand last speedweek had somebody tape our 1st run but it got erased somehow :? Good info for anyone looking for a video camera and good price too. Thanks.


                          JL222


Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #917 on: February 08, 2010, 11:26:09 AM »
Neil it was good to see you again and chat about racing.  Thanks for posting the go pro link, if I don't write it down I forget.   :-D. Looks like a great product and the audio sounds great on that boat video. :cheers:

Offline DSR88

  • Full Member
  • ***
  • Posts: 150
Re: Getting ready for Bonneville(rebuild)
« Reply #918 on: February 10, 2010, 06:12:31 PM »
Hi Troy, I have been reading some of these pages on you car 63 pages is alot to read. I have always liked your guy's hot rod { impressive} 
   I seen you watched the video by your comment the D/BG motor was to shake the new car down we knew it would be good for 250 to 260 and we ended up being right. We bumped our own record 10 mph with the same engine out of the old car w/ 5 lbs less boost.As for 300 we have a bigger engine ready to go.

Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #919 on: February 10, 2010, 08:27:59 PM »
Your CC is impressive and very clean.  Good luck to you guys, but I hope we go 300 first.... :-D :-D kidding of course

Offline DSR88

  • Full Member
  • ***
  • Posts: 150
Re: Getting ready for Bonneville(rebuild)
« Reply #920 on: February 10, 2010, 09:11:30 PM »
Different classes but same GOALS and both cars have doors on them!!!!!!!!!!! Sounds like 2010 is going to be fun.Good luck to you guy's too.Your closer than we are but we will try to sneek up on ya 8-)

Offline 12go3az

  • New folks
  • Posts: 15
Re: Getting ready for Bonneville(rebuild)
« Reply #921 on: February 11, 2010, 12:21:24 PM »
Donnie told me I needed to check out your build site.    Real Nice !!
   Many years ago while brother & i were looking @ your car at B-ville  some guys came over & were discussing how & why your prochargers setup would NEVER work.    Later that same day you guys later went REALY FAST.  Made our day!
Nice car, see u in August.
                                         be safe-GO FAST! 









Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #922 on: February 11, 2010, 08:07:36 PM »
When we first built our car we were one of if not the first to have two centrifugal superchargers on an engine at Bonneville.  The looks we got every year were comical, people would come up and tell their friends;  "see those big turbos"?  Some would say that the engine compartment was a plumbers nightmare!  The car worked very good with the old set up, but it was difficult to start, tune at low RPM's, and the set up was hard on the blowers.  Now that we have our new "Build" finished, the car is more predictable.  Easier to start, computer mapping, different overdrive, better inter-cooler and so on.  The one thing that stays the same is when people see the engine they now say, look at the huge turbo!!?  Yet we still have to explain that there is a belt attached to it and it's called a centrifugal supercharger made by Procharger. :-D  

Offline robfrey

  • Hero Member
  • *****
  • Posts: 1206
    • carbinitelsr
Re: Getting ready for Bonneville(rebuild)
« Reply #923 on: February 11, 2010, 10:20:07 PM »
I'm thinking you guys are going to much faster than 300mph. The math says so! LOL. Should be a fun year for you guys.
496 BGS
carbinitelsr.com
carbiniteracing.com
carbinite.com

Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #924 on: February 12, 2010, 10:42:17 AM »
I'm thinking you guys are going to much faster than 300mph. The math says so! LOL. Should be a fun year for you guys.

We have run the numbers too and as long as we don't break anything and can make a few passes without problems then we think we'll run a great number.  The great white dyno hasn't been kind to us in the past 20 years, maybe this can be a great year.   :cheers:

Offline thundersalt

  • Sr. Member
  • ****
  • Posts: 928
    • www.americanrvservicecenter.com
Re: Getting ready for Bonneville(rebuild)
« Reply #925 on: February 12, 2010, 11:29:25 AM »
Turbos with Zoomies, howd ya do that? :-D :evil:
916 REMR
2017 AA/FRMR Bonneville Record holder 234.663
2018 AA/GRMR El Mirage Record holder 223.108
2020 AA/BGRMR Bonneville Record holder 252.438
2021 AA/BGRMR Bonneville Record holder 262.685
El Mirage 200 MPH Club
Drivers/Owners: Brian & Celia Dean

Offline hitz

  • Sr. Member
  • ****
  • Posts: 332
Re: Getting ready for Bonneville(rebuild)
« Reply #926 on: February 12, 2010, 11:41:34 AM »
big supercharger not turbo

harv

Offline thundersalt

  • Sr. Member
  • ****
  • Posts: 928
    • www.americanrvservicecenter.com
Re: Getting ready for Bonneville(rebuild)
« Reply #927 on: February 12, 2010, 03:30:41 PM »
big supercharger not turbo

harv
:-D+ :evil:=attempt at humor.  :roll:
916 REMR
2017 AA/FRMR Bonneville Record holder 234.663
2018 AA/GRMR El Mirage Record holder 223.108
2020 AA/BGRMR Bonneville Record holder 252.438
2021 AA/BGRMR Bonneville Record holder 262.685
El Mirage 200 MPH Club
Drivers/Owners: Brian & Celia Dean

Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #928 on: February 12, 2010, 11:21:29 PM »
big supercharger not turbo

harv
:-D+ :evil:=attempt at humor.  :roll:

Brian, I knew what you ment. :-D :-D :-D

Offline bvillercr

  • Hero Member
  • *****
  • Posts: 2291
Re: Getting ready for Bonneville(rebuild)
« Reply #929 on: March 05, 2010, 10:15:44 PM »
Been busy lately, so getting up to the car has been few and far between.  Tomorrow we will be taking out the blower system, the block and clutch.  It's that time of the year again. :cheers: