(Note: LANDRACING.COM donations are not tax deductible)


This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Author Topic: Liner Final Drive  (Read 3260 times)

0 Members and 1 Guest are viewing this topic.

Offline Speed Limit 1000

  • Hero Member
  • *****
  • Posts: 1176
  • Age: 70
  • Location: Denver, Colorado
Re: Liner Final Drive
« Reply #30 on: May 06, 2020, 06:23:45 PM »
What type of heat treatment on the miter gears? Are they Carburized? What is the center bore size? You idea looks great and casting your own parts is inspiring :cheers:
John Gowetski, red hat @ 221.183 MPH MSA Lakester, Bockscar #1000 60 ci normally aspirated w/N20

Offline Flat54

  • New folks
  • Posts: 14
  • Age: 65
  • Location: Hokianga New Zealand
Re: Liner Final Drive
« Reply #31 on: May 06, 2020, 06:59:17 PM »
Gears are S45C teeth are induction hardened 50-60 HRC. The body of the gear is machinable so plan is to open up bore to 40mm and fix gear to shaft using ARP shouldered ring gear bolts after trimming the boss down some.
Grant

Offline Flat54

  • New folks
  • Posts: 14
  • Age: 65
  • Location: Hokianga New Zealand
Re: Liner Final Drive
« Reply #32 on: May 12, 2020, 05:11:30 AM »
Aluminium/aluminum arrived. Need to make some chips.
Grant