(Note: Donations are not tax deductible)

This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Forum's been "upgraded".
Things will look a bit different.
A *few* posts might have gotten lost in the crossover.
PM bobc with problems, or post in "Website Suggestions".

Author Topic: 2 ProChargers- MSD "Front Drive" Unit- Kinsler Mechanical FI Manifold  (Read 497 times)

0 Members and 1 Guest are viewing this topic.

Offline Avanti Kid

  • Full Member
  • ***
  • Posts: 286
  • Location: Canyon Country, CA
  • 2006 Member of Bonneville 200 MPH Club
Hi Andy has two identical ProChargers for sale, Model D-2, Volute diameter = 10.5"; inlet = 4.5" Outlet = 3.5";Max impeller speed = 63,000 rpm, Internal gear ratio = 4.25 to 1;Volume = 2,200CFM; Max horsepower = 1,275; For sale for $1800 for both or $1,100 for one, Will consider OBO, contact Andy at a661a@yahoo.com

MSD Front Drive Unit, new never installed $1400 (our cost in 2018 was $1,833.00) made by Chris Alston's Chassis Works, precision gear drive off the engine's cam shaft in front to timing cover, not belt driven, will fit any 8 cylinder motor, need adapter to cam shaft.

Kinsler mechanical fuel injection Manifold only, $900.00 This cam off a Pontiac powered sprint car (that's all we know about its history) This is a cast aluminum manifold with butterfly valves, no injection nozzles. Includes clamp rings for Kinsler ram tubes-velocity stacks, (ram tubes-velocity stack not included)  all items are Or best Offer, Contact Andy at a661a@yahoo.com for any questions, thanks
Original owner of 1963 Avanti; Age 75
2006 Bonneville 200 MPH Club Member
Canyon Country, CA
215.6 mph 289 CI Studebaker engine

Offline Jack Gifford

  • Hero Member
  • *****
  • Posts: 1314
  • Age: 79
  • Location: Phelps, NY
email sent
M/T Pontiac hemi guru (or does guru status expire after 30 years?)