« previous next »
Pages: [1]   Go Down

Author Topic: Repop Frame  (Read 2167 times)

0 Members and 1 Guest are viewing this topic.

Offline devilgarageco

  • New folks
  • Posts: 5
    • Devil Garage Co.
Repop Frame
« on: December 19, 2018, 05:25:28 PM »
Not sure if this has been addressed before, but, if I'm running a reproduction of a production frame, would it still qualify for the production frame class or does it need to have numbers from the factory? I'm guessing yes, but just wanted to check.

 :evil:
Logged

Offline Stainless1

  • Administrator
  • Hero Member
  • ***
  • Posts: 8964
  • Robert W. P. "Stainless" Steele
Re: Repop Frame
« Reply #1 on: December 19, 2018, 07:46:31 PM »
Be prepared to show it is 100% identical to the original, no extra gussets... basically impossible to tell from the original.... and do that in advance of the race for approval from the bike guys listed in the rule book. 
Good Luck  :cheers:
Logged
Stainless
Red Hat 228.039, 2001, 65ci, Bockscar Lakester #1000 with a little N2O

Offline panic

  • Sr. Member
  • ****
  • Posts: 845
    • My tech papers
Re: Repop Frame
« Reply #2 on: December 20, 2018, 09:04:22 AM »
Yes - wall thickness, alloy, length of inserted dowels at intersections. Take photos before sandblasting etc.
Equal or lesser weight than a known OEM probably helps.
Logged
Pages: [1]   Go Up
« previous next »