(Note: Donations are not tax deductible)

This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Forum's been "upgraded".
Things will look a bit different.
A *few* posts might have gotten lost in the crossover.
PM bobc with problems, or post in "Website Suggestions".

Author Topic: Helmet Lugs  (Read 1265 times)

0 Members and 1 Guest are viewing this topic.

Offline Elmo Rodge

  • Hero Member
  • *****
  • Posts: 1539
  • Location: Smack dab in the middle of Utah
Helmet Lugs
« on: April 26, 2018, 02:56:10 PM »
I have a new Pyrotect helmet. I need 6mm X 1.0 pitch lugs for my head and neck restraint. Who has them? DJ says they can't sell them.  :?
Wayno

Offline jimmy six

  • Hero Member
  • *****
  • Posts: 2579
  • Age: 75
  • Location: SoCal
Re: Helmet Lugs
« Reply #1 on: April 27, 2018, 04:57:33 PM »
How about the head/neck device. That's where I got mine. My new helmet had the holes and my and the recievernuts cast into them where the older one did not.
First GMC 6 powered Fuel roadster over 200, with 2 red hats. Pit crew for Patrick Tone's Super Stock #49 Camaro

Offline Elmo Rodge

  • Hero Member
  • *****
  • Posts: 1539
  • Location: Smack dab in the middle of Utah
Re: Helmet Lugs
« Reply #2 on: April 27, 2018, 06:35:50 PM »
Same situation. The new helmet has them cast in and they're metric. Restraint is DJ and they don't have them.
Wayno