« previous next »
Pages: [1]   Go Down

Author Topic: 9" Ford 2.56:1 ratio 28 spline Ring and Pinion.  (Read 1480 times)

0 Members and 1 Guest are viewing this topic.

Offline R1150GS

  • New folks
  • Posts: 1
9" Ford 2.56:1 ratio 28 spline Ring and Pinion.
« on: April 09, 2018, 11:28:23 PM »
Hi all,

I am new here to your board, but have out to the salt many times as a spectator.  I tend to be out on the motorcycle days.

A friend of mine has a gear set that may interest the group...

Ford 9"  ratio is 2.56:1 (16 tooth pinion, 41 tooth ring), the pinion has a 28 spline input.  This gear set shows that it has been installed and run for a few miles, but removed shortly after.

The gears are as new.

If there is any interest I can get a few photos for you...  in the box they came in.

Best Regards,

Jim
Logged

Offline 8

  • New folks
  • Posts: 21
Re: 9" Ford 2.56:1 ratio 28 spline Ring and Pinion.
« Reply #1 on: April 15, 2018, 04:03:25 PM »
Can you post pictures, and price ?
Logged

Offline jimmy six

  • Hero Member
  • *****
  • Posts: 2786
Re: 9" Ford 2.56:1 ratio 28 spline Ring and Pinion.
« Reply #2 on: April 16, 2018, 02:30:52 PM »
May not be a Ford but aftermarket. Fords were usually 2.47. Could be one used by NASCAR since they had made many "unheard of" ratios. Pontiac 57-63 did have a 2.56 and were very similar to the Fords in appearance. A set got me in the B'ville 2 club.
Logged
First GMC 6 powered Fuel roadster over 200, with 2 red hats. Pit crew for Patrick Tone's Super Stock #49 Camaro
Pages: [1]   Go Up
« previous next »