(Note: Donations are not tax deductible)

This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Forum's been "upgraded".
Things will look a bit different.
A *few* posts might have gotten lost in the crossover.
PM bobc with problems, or post in "Website Suggestions".

Author Topic: Sheet Metal Intake Manifold.  (Read 117594 times)

0 Members and 1 Guest are viewing this topic.

Offline tauruck

  • Hero Member
  • *****
  • Posts: 4883
  • Location: Johannesburg, South Africa
Re: Sheet Metal Intake Manifold.
« Reply #120 on: February 17, 2019, 07:34:49 PM »
Rob, that came out great.
Looks awesome brother.  :cheers: :cheers: :cheers: :cheers: :cheers: :cheers:

Offline wobblywalrus

  • Hero Member
  • *****
  • Posts: 4957
  • Age: 65
  • Location: backwoods Oregon
Re: Sheet Metal Intake Manifold.
« Reply #121 on: February 17, 2019, 08:10:47 PM »
A paper on tapered runner design.  http://engine.osu.edu/ASJP/JP/J72.pdf