« previous next »
Pages: [1]   Go Down

Author Topic: Motec M800  (Read 2133 times)

0 Members and 1 Guest are viewing this topic.

Offline Ted Hlokoff

  • New folks
  • Posts: 22
  • sc GTS and TT GTS
    • Viper Nation
Motec M800
« on: July 01, 2014, 01:18:56 PM »
I bought a Motec M8 and wiring harness for my Viper GTS (twin turbo, 1000 - 1600whp) and I have NO instructions with it at all.  I also purchased the dash board display, GPS, etc.  Again, no instructions.

Anyone in central BC have any knowledge of the system and it's requirements
Logged
I sucessfully street raced for 25 years (Gov stole drag strip).  I built Show and Race cars for 10 years professionally.  Have been doing well racing Half, Mile and Open Road Rally last few years.  I have many Mopars in my yard, 2 Vipers, 3 Stealth TTs, 440 Duster, 340 Demon, and a dozen project cars.

Offline sabat

  • Hero Member
  • *****
  • Posts: 1538
Re: Motec M800
« Reply #1 on: July 01, 2014, 02:07:21 PM »
The Motec site has a good selection of PDFs, drawings, and webinars, I found it very helpful. Good luck, Dean

http://www.motec.com/downloads/downloadsappdrawings/
Logged

Offline Ted Hlokoff

  • New folks
  • Posts: 22
  • sc GTS and TT GTS
    • Viper Nation
Re: Motec M800
« Reply #2 on: July 02, 2014, 02:28:22 AM »
Thanks.  I look there.
Logged
I sucessfully street raced for 25 years (Gov stole drag strip).  I built Show and Race cars for 10 years professionally.  Have been doing well racing Half, Mile and Open Road Rally last few years.  I have many Mopars in my yard, 2 Vipers, 3 Stealth TTs, 440 Duster, 340 Demon, and a dozen project cars.
Pages: [1]   Go Up
« previous next »