« previous next »
Pages: [1]   Go Down

Author Topic: I NEED A H&C 6355 CAM, SOMETIMES CALLED A 408  (Read 1603 times)

0 Members and 1 Guest are viewing this topic.

Offline 38flattie

  • Hero Member
  • *****
  • Posts: 2169
    • http://www.flatcadracing.org/
I NEED A H&C 6355 CAM, SOMETIMES CALLED A 408
« on: June 04, 2013, 08:56:16 PM »
I have a special project, and want to copy a H&C 6355 cam, for a FED/gasser project.

Does anyone out there have one, or know the whereabouts of one?

Thanks in advance!


Logged
With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin

http://www.flatcadracing.org/
http://youtu.be/89rVb497_4c

Offline RichFox

  • Hero Member
  • *****
  • Posts: 2663
Re: I NEED A H&C 6355 CAM, SOMETIMES CALLED A 408
« Reply #1 on: June 04, 2013, 09:12:35 PM »
Did you ask Dema?
Logged

Offline 38flattie

  • Hero Member
  • *****
  • Posts: 2169
    • http://www.flatcadracing.org/
Re: I NEED A H&C 6355 CAM, SOMETIMES CALLED A 408
« Reply #2 on: June 05, 2013, 11:44:55 AM »
Yes I did, but he doesn't know if he has it. He's going to look and see.

I want to pattern off of an original cam, as a lot of cam grinders seem to make small 'improvements' over competitor grinds!
Logged
With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin

http://www.flatcadracing.org/
http://youtu.be/89rVb497_4c
Pages: [1]   Go Up
« previous next »