Tonight I finished making the templates for the 3mm sheet metal gussets.
I added a pair of CrMo tubes just below where the seat will be to lighten the load on the weld where the single upper frame tube ends.
At his point I removed the engine to see if any of the tubes would be in the way, they weren´t so I continued by removing the oil and kero tanks and air intake so I could add a couple of strengthening tubes between the lower frame tubes.
Here you can see them a bit clearer.
The biggest progress tonight is probably that I think I have figured out how to make the seat and the rear fairing for the bike, I won´t tell you in case I change my mind but if it works it should look pretty good.
Cheers!
/Anders