Author Topic: high pressure pump  (Read 17702 times)

0 Members and 1 Guest are viewing this topic.

Offline hawkwind

  • Sr. Member
  • ****
  • Posts: 415
high pressure pump
« on: February 11, 2013, 12:41:27 AM »
gday..... Does such a beast exist looking for a 12vdc water pump that can do 300psig minimum and 7 ltrs an hour ? searching has found only up to 160psig...chasing 1 micron droplets through a fogger nozzel and 300psig is the minimum pressure needed.Setting up a pre compressor impeller (turbo)water injection system...... if a pump is not available has anyone used compressed air as the pressure source?

cheers
Gary
slower than most

Offline Jon

  • Sr. Member
  • ****
  • Posts: 852
Re: high pressure pump
« Reply #1 on: February 11, 2013, 02:36:43 AM »
Can you run two of the 160psi units in series?

Running gas class to be using water?

Cheers
jon
Underhouse Engineering
Luck = Opportunity + Preparation^3

Offline manta22

  • Hero Member
  • *****
  • Posts: 4137
  • What, me worry?
Re: high pressure pump
« Reply #2 on: February 11, 2013, 12:14:17 PM »
Gary;

I think the compressed air idea is the best approach. It should not take a large air tank since the volume of water injected will not be too large. A standard 2200psi tank with a regulator should work.

A 300psi water pump is mighty hard to find.

Regards, Neil  Tucson, AZ
Regards, Neil  Tucson, AZ

Offline bigtim44

  • Full Member
  • ***
  • Posts: 134
  • NaCl addict
Re: high pressure pump
« Reply #3 on: March 02, 2013, 12:45:28 PM »
For our diesel truck we have a self contained water/meth injection system which is 12v dc powered and delivers water/meth at pressures up to 600psi,its fully adjustable too,the outfit that puts the setup together is called Scheid diesel.
Salty Box Racing #622 B/DT

Offline Ron Clevenger

  • New folks
  • Posts: 15
Re: high pressure pump
« Reply #4 on: July 22, 2013, 11:22:33 PM »
I've been fooling around with water/meth injection since the early 70's. Used air tank pressure and high pressure pumps. One of the best systems out there today is http://www.alcoholinjectionsystems.com/Water-Injection-Pump/c29/index.html. His pumps will go to 250 psi. If your going that high it's recommended to use two pumps to maintain a solid pressure and volume. His nozzels work very well and are designed for his pumps. Rodney the owner knows his business and eat-sleeps and dreams about water/meth systems.

Blessings.........Ron C

Offline Crackerman

  • Full Member
  • ***
  • Posts: 206
Re: high pressure pump
« Reply #5 on: July 23, 2013, 01:28:22 AM »
12vdc haldex hydraulic pump. Water and meth cut with some light oil and you will have all the psi you need. Will need a charging system to handle it though.