Mark Williams coupler

[Rick Byrnes]

Used only 6 passes & decided I wanted suspension.
MW 32 spline 1.375" shaft
MW 40603A for 10spline rear. V8 or midget center
MW 40640A female coupler
MW 40780 male coupler
2 stainelss lock rings and 2 4130 lock rings

All parts except the lock rings are Non-Electrolitic Nickle plated
(no hydrogen embridlement)

Want $300
Rick@RBMotorsports.com

[Glen]

Rick what  is the length?

[Rick Byrnes]

HI Glen
only 8 inch length.

[kiwi belly tank]

Rick,
What material is the shaft?
What is the trans coupler?
Where are you measuring the 8"?
  Sid.

[Rick Byrnes]

Sid
8 inch is overall length.
I'm guessing the shaft is 4130 which is their base alloy, but I didn't originally purchase the parts.
Trans is Jerico 4 spd clutchless and I think is 32 spline.  I will go out to the shop and count.  First I need to cut the grass which will keep the little red haired girl happy.  Later today.

[kiwi belly tank]

My front one is 13" but it might fit the rear. I'll be putting the B&J back in to check length while you're on the grass.
  Sid.

[Rick Byrnes]

Sid
The trans coupler is 32 spline, but about .010" smaller diameter than the shaft and other parts which of course makes the splines a little finer.  When I replaced the coupler, I ended up with a real bastard flange for u joint and 2 piece shaft.  Kinda like a 4WD front shaft.
Hope this helps

[kiwi belly tank]

Sent you a pm.
  Sid.

[Rick Byrnes]

bump

[Tman]

Rick, thanks for shooting me a note. I will look at my stuff and see if this will work tonight.