(Note: LANDRACING.COM donations are not tax deductible)


This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Author Topic: July Videos - Post Here  (Read 5858 times)

0 Members and 1 Guest are viewing this topic.

Offline Roland6250

  • Full Member
  • ***
  • Posts: 81
  • Age: 60
  • Location: Southern New Jersey
    • My Powered Streetluge Project
Re: July Videos - Post Here
« Reply #15 on: July 19, 2012, 04:15:22 PM »
Powered Streetluge motor - 1200cc but the motor has been built high speeds.  Engine work was done by me but the machine shop work was done by Andy Simons of Simon’s Competition out of Langhorne PA. www.simonscompetition.com
  • Heads where pocket ported with bee hive springs, nitrate coated light weight valves and light weight caps
  • Cylinders where bored 5 over standard and wisco stock cast pistons installed
  • Trans was rebuilt and has back cut gears
  • Non rev limiting Dyna ignition
  • Jims lifters, Jims pushrods and stock cams
  • S&S Super B carb with S&S intake

Dyno recorded 85 hp to the rear wheel and a top speed of 193mph.

Offline N.F.S.

  • Full Member
  • ***
  • Posts: 66
  • Age: 49
  • Location: Monticello,Maine
  • need for speed
Re: July Videos - Post Here
« Reply #16 on: July 19, 2012, 04:44:12 PM »
Powered Streetluge motor - 1200cc but the motor has been built high speeds.  Engine work was done by me but the machine shop work was done by Andy Simons of Simon’s Competition out of Langhorne PA. www.simonscompetition.com
  • Heads where pocket ported with bee hive springs, nitrate coated light weight valves and light weight caps
  • Cylinders where bored 5 over standard and wisco stock cast pistons installed
  • Trans was rebuilt and has back cut gears
  • Non rev limiting Dyna ignition
  • Jims lifters, Jims pushrods and stock cams
  • S&S Super B carb with S&S intake

Dyno recorded 85 hp to the rear wheel and a top speed of 193mph.


Thanks just wondering because speed you where getting but than again it's not in a motorcycle chassis either.

Offline saltwheels262

  • Hero Member
  • *****
  • Posts: 1081
  • Age: 66
  • Location: cumberland plateau
  • LTA 7/2013
Re: July Videos - Post Here
« Reply #17 on: July 19, 2012, 05:21:21 PM »
169+ is a pretty good speed for a 74 cubic inch engine.

what is the overall gearing on your ride ?

bf
bub '07 - 140.293 a/pg   120" crate street mill  
bub '10 - 158.100  sweetooth gear
lta  7/11 -163.389  7/17/11; 3 run avg.-162.450
ohio -    - 185.076 w/#684      
lta 8/14  - 169.xxx. w/sw2           
'16 -- 0 runs ; 0 events -- made a 2 state change in ZIP codes

" it's not as easy as it looks. "
                            - franey  8/2007

Offline 55chevr

  • Hero Member
  • *****
  • Posts: 2247
  • Location: Long Island, NY
Re: July Videos - Post Here
« Reply #18 on: July 19, 2012, 05:48:57 PM »
My mistake ... it was a B carb, not an E ... Joe