(Note: LANDRACING.COM donations are not tax deductible)


This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Author Topic: Intake air flow question  (Read 1274 times)

0 Members and 1 Guest are viewing this topic.

Offline Clay Pitkin

  • Full Member
  • ***
  • Posts: 207
  • Location: Clinton Utah
    • B&B Racing
Intake air flow question
« on: June 29, 2012, 07:46:13 PM »
Ok Have a question and need some help please:

I am going to be running my air intake tube to the front of the car.

It will only make one turn and that's going into the air box that mounts to my carbs.

I want to make the air flow as efficient as possible.

I was told that some designs are doing more harm than good because the air swirls in the tube and does not go into the carbs as fast as it should.

Can this be true?

How do I test for this, or design it for maximum efficiency? The carbs on this engine is right against the firewall, so I need all the air flow I can get.

TIA
Clay
Those who said it could not be done, should not stand in the way of those who are already doing it!

Offline Jon

  • Sr. Member
  • ****
  • Posts: 852
  • Age: 52
  • Location: Brisbane, Australia
Re: Intake air flow question
« Reply #1 on: June 29, 2012, 08:23:13 PM »
If you are looking for preassure recovery (very low boost from the car going forward) you want the air to be pretty much stopped at the carburetor mouth.

That is usually achieved by a correctly sized inlet (smallish) running into a big airbox.

Unless the dueling system is set up to cope with a rising rate regulator etc it can lead to fueling problems.

There is a bit in getting it right.

My $.02
jon
Underhouse Engineering
Luck = Opportunity + Preparation^3

Offline kiwi belly tank

  • Hero Member
  • *****
  • Posts: 2629
  • Age: 168
  • Location: Lava Hot Springs Idaho
Re: Intake air flow question
« Reply #2 on: August 15, 2012, 09:33:49 AM »
Lots of variables, pm sent.
  Sid.