(Note: Donations are not tax deductible)

This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?


Forum's been "upgraded".
Things will look a bit different.
A *few* posts might have gotten lost in the crossover.
PM bobc with problems, or post in "Website Suggestions".

Author Topic: Motorcycle Ground Clearance  (Read 7859 times)

0 Members and 1 Guest are viewing this topic.

Offline bak189

  • Sr. Member
  • ****
  • Posts: 761
  • Age: 82
  • Location: CA. AZ. Netherlands
Re: Motorcycle Ground Clearance
« Reply #15 on: January 25, 2012, 06:12:10 PM »
Yes,,,,we get 51hp out of the 650c.c. pre-unit Tri......65hp out of the 750c.c. Chatland kit....plan to install steel con-rods and up the comp.....so maybe 70hp if we are lucky.......you got to love these old bikes..............................
Question authority.....always

Offline Nortonist 592

  • Hero Member
  • *****
  • Posts: 1508
  • Location: Riverside CA.
    • http://www.artfv.com/design/fashion/
Re: Motorcycle Ground Clearance
« Reply #16 on: January 25, 2012, 06:33:20 PM »
you got to love these old bikes..............................

But keep an close eye on the new ones.

By weslake at 2012-01-24
Get off the stove Grandad.  You're too old to be riding the range.

Offline oz

  • Sr. Member
  • ****
  • Posts: 587
  • Age: 55
  • Location: Leighton Buzzard GB
  • Geordie Power.
Re: Motorcycle Ground Clearance
« Reply #17 on: January 26, 2012, 12:25:21 PM »
My Ballast has increased by almost 7kg since christmas, I reckon i need to get some excercise soon or my aerodynamics is gona be shot to bits and my new leathers will have to be binned!!

Oz
Newcastle born and bred a City built on Coal and Steel and a people built of stronger stuff

Offline Peter Jack

  • Hero Member
  • *****
  • Posts: 3657
  • Age: 75
  • Location: Calgary, Alberta
Re: Motorcycle Ground Clearance
« Reply #18 on: January 26, 2012, 04:36:07 PM »
Obviously just a slight material flaw. That'd get your attention going on between your legs! :-o :-o :-o

Pete