(Note: LANDRACING.COM donations are not tax deductible)

This is a public forum. The opinions expressed here don't
necessarily reflect the feelings of The Folks That Run The Site (that's us)
unless we explicitly say so, ok?

Author Topic: SBC SFI Scattershield  (Read 1730 times)

0 Members and 1 Guest are viewing this topic.

Offline 38flattie

  • Hero Member
  • *****
  • Posts: 2168
  • Age: 57
  • Location: Greeley, Colorado
    • http://www.flatcadracing.org/
SBC SFI Scattershield
« on: July 30, 2011, 07:01:35 PM »
Due to a last minute engine swap, we need a SFI  bell housing and gear drive starter, for a SBC.

With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin


Offline salt27

  • Hero Member
  • *****
  • Posts: 1493
  • Age: 63
  • Location: S.W. Orygun
Re: SBC SFI Scattershield
« Reply #1 on: July 31, 2011, 01:11:52 AM »
What size flywheel?