Landracing Forum
East Coast Timing Association => ECTA General Chat => Topic started by: stobl on February 19, 2011, 03:43:01 PM
-
Hi Everyone,
As I'm trying to finish up the ride in hopes of getting a meet or two in before this year passes by, I finally need to order the seat. I've been looking at the ultrashield vs halo to comply with the new rules, but instead of guessing as to what size i need, I was wondering if anyone usually shows up to maxton with a few to try on for size? I have a 17" drag seat that's now too big on me, and I'd rather be sure i need a 15" vs 16" instead of guessing. I saw Joe at DCW is a dealer, but couldn't see if they brought any with them to maxton. I'm up in northern Virginia also, if anyone knows of a dealer in the local area that has some to try.
Thanks for the help,
Blake
-
I am pretty sure Joe has brought a seat down to Maxton in the past. You should contact him and see if he has a 16 in stock that he might be able to bring down.
-
We installed an 18", 20° seat - come and try it on.
Geo Turner
Geezer Racing
-
Thanks for the help guys, I'll give him a ring and see about bring a 16" in april
-
Thanks for the help guys, I'll give him a ring and see about bring a 16" in april
I think the display seat Joe brought a time or two before was either a 16" or 18".... make sure you are fully suited up when you try a seat...if a 16" seat is correct in Jeans,, then depending on your suit and gear a 17" or 18" may be the correct size in the end.
Good luck,
Charles