Landracing Forum
Misc Forums => How To Section => Topic started by: Slide on August 30, 2016, 01:13:17 PM
-
Anyone have any solutions already engineered up for race ramp storage on an open trailer? I have setteld on a 20 ft Featherlite...and then someday getting their wheel rack. I figure then I can fab up a holder for my race ramps. But instead of reinventing the wheel, I thought i would see if anyone has it sorted.
I could not find anything prefab'd
-
Thought I had a photo, but can't find one. I bought a new 68" x 12' Aluma trailer for my lakester, with aluminum arched 6' ramps. I had the dealer weld a pair of "stakes" on one side of each ramp which sit in stake-pockets along each side near the front of the trailer's side rails. A latch pin holds each one in place. Works well.
Edit: I found a picture.
-
Im sorry, I meant a set of these (Pic found from interwebs. The ones I have are their 80 inch long ones)
(http://www.carid.com/images/race-ramps/garage-accessories/rr-80-10-2.jpg)
-
They sure look like candidates for a tongue mounted storage box.
Jack, as per usual, a nice clean solution for what can be a perplexing problem. :cheers: :cheers: :cheers:
Pete
-
They sure look like candidates for a tongue mounted storage box.
Jack, as per usual, a nice clean solution for what can be a perplexing problem. :cheers: :cheers: :cheers:
Pete
They are 80 inches long. Not sure how they will fit in a tongue box?
-
It looked to me like they were in two sections. Is there a web site?
Pete
-
Raceramps.com
Tons of different variations.
-
Lots of different configurations. Should be able to come up with something with a race ramp and another for something really shallow and all components that would fit in a tongue mounted box.
Pete