Landracing Forum
Misc Forums => How To Section => Topic started by: floydjer on February 11, 2016, 10:25:29 AM
-
www.yoube.com/watch?v=HBanmfn CA
-
The link takes you to ebay?
-
Hmmmmm.........www.youtube.com/watch?v=HBanmfnCA
-
I notch tubing with my Portaband . 2 straight cuts mates any 2 tubes .
-
Well gosh....I use me Index 745 Verticle mill......but that vid. is another way. :cheers:
-
www.youtube.com/watch?v=mHBanmfn_CA
Try this :-D
Great video, makes it look easy. :cheers:
-
I had migrated to the Chop saw on the weird cuts-- but without the math---can not wait to try it with the math---should be able to make much better copes!!!!!!!
-
Darn those underscores...... :cheers:
-
www.youtube.com/watch?v=mHBanmfn_CA
Try this :-D
Great video, makes it look easy. :cheers:
THAT worked, thanks. Makes it look easy.
-
Actually it IS easy.
Even the super pros have to do a little hand grinding for a good fit.
You just have to do a little more this way. Get one of those round edge flapper discs for your grinder and it gets REAL easy! :cheers:
-
I think I notched over 200 tubes on the long car.
Starrett Hole saw on the drill press holding with a vice.
I have a brand new tube notcher here that I never used. :dhorse: